Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 102

ALTERNATOR/STARTER CLUTCH
Install the starter idle/reduction gear with the longer shaft.
Install the starter drive gear with the "OUT" mark facing out
and the shorter shaft, if the gear is removed.
Install the dowel pins and new gasket.
LEFT CRANKCASE COVER INSTALLATION
Install the left crankcase cover and tighten the cover bolts with
the neutral and oil pressure switch wire harness clamps as
shown.
Route the alternator wire and connect the alternator 3P con-
nector.
Install the drive sprocket cover.
Install the gearshift arm onto the spindle by aligning the punch
mark on the arm with the punch mark on the spindle.
Tighten the gearshift arm pinch bolt.
TORQUE: 12 N'm (1.2 kg-m. 9 ft-Ib)
Install the drive sprocket cover.
Check the engine oil level and add the oil if necessary.
8-6
- ~ ~
(1)
DRIVE SPROCKET COVER
- - ' = =