Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 184

REAR WHEEL/SUSPENSION
LOWER MOUNTING BEARING REPLACEMENT
Remove the dust seals from the lower mount.
Press the needle bearing out of the shock absorber with the
special tool.
Apply clean grease to a new needle bearing and drive it into
the shock absorber until it is flush with lower mount surface.
Apply clean grease to the dust seal lips and install them onto
the lower mount.
TOOL:
Spherical bearing driver
TOOLS:
Driver
Attachment 24 x 26 mm
Pilot 17 mm
07946 - KA30200
Not available in U.S.A.
07749-0010000
07746-0010700
07746-0040400
(1) DRIVER
/
INSTALLATION
Install the lower mounting collar into the mount.
Install the shock absorber in the frame with the drain tube
facing forward.
Tighten the shock absorber upper mounting bolt.
TORQUE: 65 N'm (6.5 kg-m, 47 ft-Ibl
Install the fuel filter base and mounting bolt.
TORQUE: 22 N'm (2.2 kg-m. 16 ft-Ibl
Install the sub-frame upper mounting bolts.
TORQUE: 40 N·m (4.0 kg-m. 29 ft-Ibl
Tighten the sub-frame lower mounting bolts.
TORQUE: 40 N'm (4.0 kg-m, 29 ft-Ibl
13-18
(1)
SHOCK ABSORBER
(2) LOWER MOUNTING
COLLAR
(4) FUEL FILTER
BASE MOUNTING BOLT