Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 130

CYLINDER/PISTON
Coat the cylinder. piston rings/grooves and piston with clean
engine oil.
Install the piston assembly into the cylinder from the top of the
crankcase while compressing the piston rings with your fin-
gers.
Be sure each assembly is returned to its original position as
noted during removal.
NOTE
Be careful not to damage the piston rings during assembly.
When the cylinder is halfway over the piston. route the cam
chain through the cylinder.
Install a new a-ring onto the cylinder joint and install the cylin-
der joint collar by sliding the collar toward either cylinder.
Install the clips securely.
Install a new a-ring into the connector and install and tighten
the connector mounting bolts, if the connector was removed.
If only the water hose was removed, connect the hose with
the clamp.
Clean the cylinder gasket surface.
NOTE
• Avoid damaging the gasket surface.
Install the cam chain guide.
NOTE
Align the guide boss with the groove in the cylinder.
Make sure that the end of the guide is inserted into place in
the crankcase.
Install the dowel pins and a new gasket.
Install the cylinder heads and covers (Section 9).
10-6