Honda 88-91 NT650 HAWK GT Serviceanleitung Seite 155

FRONT WHEEL/SUSPENSION/STEERING
Install the left handlebar onto the fork tube in the same manner
as a right handlebar.
Connect the choke cable to the choke lever.
Install the left handlebar switch by aligning the locating pin
with the hole in the handlebar.
Tighten the front screw first, then tighten the rear screw.
Install the right rear view mirror in the holder.
Secure the wires with wire bands.
(1) LOCATING PIN
Install the clutch lever and holder with the "UP" mark facing
up.
Align the end of the holder with the punch mark on the handle-
bar and tighten the upper bolt first then tighten the lower bolt.
TORQUE:
12
N·m
(1.2
kg-m.
9
ft-Ibl
Adjust the following:
- throttle operation and free play (page 3-41-
- clutch lever free play (page 3-16).
12-6
(2) RETAINER RING