Applying Velcro® To The 0747 Stretcher - Stryker Ultra Comfort SE Bedienungsanleitung

English
Preventive maintenance (Continued)
EN
Product serial number:
Completed by:
Applying Velcro® to the 0747 stretcher
WARNING
Always apply the supplied Velcro to the 0747 stretcher to make sure that the mattress is secure. Non-use may result in
patient harm due to mattress movement.
• (1) Fowler (A) Velcro pile (0785-034-007)
Note: This kit is to attach the mattress to the Model 0747 Transport Stretcher frame. If the Velcro pattern on the
mattress does not match the pattern on the frame, please follow these instructions.
Tools required
• Tape measure
Procedure
Note: Remove the product from service before you perform this upgrade.
1. Raise the product to the highest height position.
2. Remove and save the mattress.
3. Push down on the brake pedal to apply the brake.
4. Wipe the surface with isopropyl alcohol (70% alcohol).
5. Allow the surface to dry for at least two minutes.
6. Remove the backing on the fowler Velcro (A) and apply the Velcro to the surface of the fowler
1-10).
7. Press on the center of the Velcro and all edges to secure to the surface.
8. Allow the adhesive to cure for at least one hour before you return the product to service.
Note: For best results, allow the adhesive to cure for 24 hours before you return the product to service.
1-10
Operation
• (2) Velcro pile (adhesive back) (B) (0785-034-005)
Figure 1-1: Apply Velcro to the fowler
1704-009-005 REV C
Date:
(Figure 1-1 on page
A
www.stryker.com