CITO RSP System 2.0 Bedienungsanleitung Seite 86

86
Operating Manual
Recommendation for Selection of RSP Offset Creasing Matrices
Thickness of material
0.10 mm
0.15 mm
0.20 mm
0.25 mm
0.30 mm
0.35 mm - 0.50 mm
Note:
The value mentioned above are guide numbers and are therefore not binding.
The following factors have an important influence on the correct creasing strip:
• Pressure supply
• Hardness of material to be imprinted
• Humidity of material to be imprinted
• Makeready of the base blanked
with lines with felxible dies
0.3 × 0.7 mm
0.3 × 0.8 mm
0.3 × 1.0 mm
0.3 × 1.0 mm
0.3 × 1.2 mm
0.3 × 1.3 mm
0.2 × 0.8 mm
0.2 × 0.8 mm
0.2 × 1.0 mm
0.2 × 1.0 mm
0.2 × 1.2 mm
–