Installation Instructions For Rsp System 2.0 (Generally); St Step: Mounting The Rsp Protective Impression Cylinder Jacket - CITO RSP System 2.0 Bedienungsanleitung

3. Installation instructions
for RSP System 2.0
54
Operating Manual
1
Important note:
Use the RSP System 2.0 only with original accessories!
When using the RSP System 2.0 declamp blanket and offset printing plate in the respec-
tive printing unit!
Switch off the ink ductor, inking form and dampening form rollers.
When using in the coating unit: Remove the coating roller!
With two-roller coating units, set the spacing between the blanket cylinder and application
roller to the maximum distance!
Never use damaged or worn RSP system components!
When installing and removing the RSP protective impression cylinder jacket, we recom-
mend wearing safety gloves (RSP accessories).
To remove the RSP protective impression cylinder jacket safely and easily, we recommend
our removal aid (RSP accessories).
1 Step: Mounting the RSP protective impression cylinder jacket
st
• Clean the impression cylinder prior to fixing IPA.
• Set the respective printing unit manually to "print" and the spacing from blanket cylin-
der to impression cylinder to 0.00 mm.
• Remove about 5 cm of the protective tape from the front edge of the protective
impression cylinder jacket and affix the protective impression cylinder jacket about
3 mm from the impression grippers and in the middle of the sides to the clean impres-
sion cylinder at the print start (Fig. 1).
(generally)
2
1
3