Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Then gradually remove protective tape from the protective impression cylinder jacket,
inch the impression cylinder forward in intervals and glue on the protective impression
cylinder jacket.
•
Let the press make three cylinder rotations in order to mangle the protective impres-
sion cylinder jacket to the impression cylinder. Then switch off impression again.
•
Secure the protective impression cylinder jacket with the enclosed adhesive tape at
print start and tail edge; after longer machine down-times check the adhesiveness
before the start-up of the machine (Fig. 2).
•
Set the distance from blanket cylinder to impression cylinder to 0.35 mm.
Attention:
Protective impression cylinder jackets cannot be used on jacket sheets "Perfect Jack-
ets" of Heidelberg presses! In case of roughened protective impression cylinder jackets
(Mark3) it is absolutely necessary to use protective impression cylinder jackets "Perfektor"
after perfecting.
The protective impression cylinder jackets and guaranteed for one single use only!
1
2
Operating Manual
2
3
55
Werbung
Kapitel
Fehlerbehebung
