Siemens SINUMERIK 840D sl Inbetriebnahmehandbuch Seite 1040

System konfigurieren
2.3 Konfigurationsdatei "basesys.ini"
; If EnableSysNetToIBNForwarding is set to 1, the NCU forwards
packets from
; X120 to X127. (Please note that the sending host must be able to
route
; the packets to the NCU by its own means, the NCU just accepts and
forwards
; packets to 192.168.215.x with this setting.)
;EnableSysNetToIBNForwarding=1
[SNMP]
; The following variables define strings which are delivered on
; certain SNMP requests.
; SNMPLocation and SNMPContact are reported for the standard OIDs
; SNMPv2-MIB::sysLocation and SNMPv2-MIB::sysContact, resp.
; SNMPAutLocation and SNMPFunction are used in the Siemens A&D
specific
; AUTOMATION-SYSTEM-MIB as
automationSystemIdent.automationLocationTag
; and automationSystemIdent.automationFunctionTag, resp.
SNMPLocation="not specified"
SNMPContact="not specified"
SNMPAutLocation="not specified"
SNMPFunction="not specified"
SNMPStation=""
[DCP]
; These variables en/disable the DCP protocol on X120/X127
; and X130, resp.
;InternalDcpEnabled=0
;ExternalDcpEnabled=1
[LLDP]
; These variables en/disable the LLDP protocol on X120/X127
; and X130, resp.
;InternalLldpEnabled=0
;ExternalLldpEnabled=1
32
Inbetriebnahmehandbuch, 10/2015, 6FC5397-1DP40-5AA3
Betriebssystem NCU (IM7)