Safety During Operation; Safety During Maintenance; 1.13.1 Switching-Off And Securing The Drilling Milling Machine; Using Lifting Equipment - Optimum OPTidrill DH 40CT Betriebsanleitung

Personal protective equipment for special works
Wear protective gloves when handling pieces or tools with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Protect your face and your eyes: Wear a safety helmet with facial protection when performing
work where your face and eyes are exposed to hazards.
Before starting work make sure that the required personal protective equipment is available at
the work place.
1.12

Safety during operation

We provide information about the specific dangers when working with and on the drilling milling
machine in the descriptions for these types of work.
WARNING!
Before switching on the drilling milling machine make sure that there are

there is no risk to persons,

no objects are damaged.
Avoid any unsafe work methods:

Make sure that your operation does not create a safety hazard.

The rules specified in these operating instructions must be observed during assembly,
operation, maintenance and repair.

Do not work on the drilling milling machine, if your concentration is reduced, for example,
because you are taking medication.

Observe the accident prevention regulations issued by your Employers Liability Insurance
Association or other supervisory authorities applicable to your company.

Inform the supervisor about all hazards or faults.

Stay at the drilling milling machine until the movements have stopped completely.

Use the prescribed personnel protective equipment. Ensure you wear close-fitting clothing
and, if necessary, a hairnet.

Do not use protective gloves when drilling.
1.13

Safety during maintenance

Inform the operators in good time of any maintenance and repair works.
Report all safety-relevant changes and performance characteristics of the drilling milling
machine. Any changes must be documented, the operating instructions updated and machine
operators instructed accordingly.

1.13.1 Switching-off and securing the drilling milling machine

Switch off the machine by turning off the master switch before starting any maintenance and
repair work.
Use a padlock to prevent the switch from being turned on without authorization and keep the
key in a safe place.
All machine parts as well as all dangerous voltages are switched off. Excepted are only the
positions which are marked with the adjoining pictogram.
Attach a warning sign to the machine.
1.14

Using lifting equipment

WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death.
EN DH 40CT
64 Translation of original instruction
Safety
Version 1.0.1 - 2021-07-06