For Your Own Safety During Operation; Switching-Off And Securing The Drilling- Milling Machine; Using Lifting Equipment - Optimum OPTImill MB 4 Betriebsanleitung

Wear protective gloves when handling pieces with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the required personal protective equipment is available at
the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness. It must be
cleaned after each use and at least once a week.
1.12

For your own safety during operation

WARNING!
Before activating the drilling- milling machine, ensure that this will not endanger other
persons or cause damage to equipment.
Avoid any unsafe work methods:
Make sure that your operation does not create a safety hazard.

The rules specified in these operating instructions must be observed during assembly,
operation, maintenance and repair.

Use protective glasses!

Switch off the drilling- milling machine before measuring the workpiece.

Do not work on the drilling- milling machine, if your concentration is reduced, for example,
because you are taking medication.

Stay on the drilling- milling machine until the working spindle has come to a complete stand-
still.

Use the specified personal protective equipment. Ensure you wear close-fitting clothing
and, if necessary, a hairnet.

Do not use protective gloves when drilling or milling.

Disconnect the shock-proof plug from the outlet before replacing the tool.

Use appropriate agents to remove drilling and milling chips.

Ensure that your work does not create a safety risk.

Safely and firmly clamp the workpiece in place, before switching the drilling- milling machine
on.
We provide information about the specific dangers when working with and on the drilling- milling
machine in the descriptions for these types of work.
1.13

Switching-off and securing the drilling- milling machine

Disconnect the mains plug before starting maintenance and repairs.
1.14

Using lifting equipment

WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death.
Check that the lifting and load suspension equipment are of sufficient load-bearing
capability and are in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other supervisory authorities applicable to your company.
Fasten the loads properly.
Never walk under suspended loads!
EN MB4
58 Translation of original instruction Version 1.0.1 - 2021-11-18