Elcometer 307 Gebrauchsanleitung Seite 11

5 SETTING LIMITS (continued)
If a measurement is taken which falls
outside set limits, the appropriate limit icon,
the reading value and the reading
differential (if enabled) turn red, the red
LED flashes and the alarm beeps.
5.4 RENAMING LIMITS
1 Press Menu/Limit Memories/Edit Limit Memory/Rename Limit
Memory.

2 Use the
and press 'Select'.
Use the  softkeys to rename the limit memory.
3
4 Select 'Ok' to save the changes or 'Escape' to exit and disregard
any amendments made.
5.5 AMENDING LIMITS
1 Press Menu/Limit Memories/Edit Limit Memory/Amend Limit
Memory.

2 Use the
amended and press 'Select'.

3 Use the
Limit') and press 'Select'.

4 Use the
5 If required, repeat Steps 3-4 for 'Set Lower Limit' (or 'Set Upper
Limit') and 'Set Nominal'.
6 When all values have been amended as required, use the
softkeys to highlight 'Save Limit Memory n' and press 'Select' to
save the changes.
www.elcometer.com
softkeys to highlight the limit memory to be renamed

softkeys to highlight the limit memory to be

softkeys to highlight 'Set Upper Limit' (or 'Set Lower

softkeys to set the required value and press 'Set'.

R


en-10