Elcometer 307 Gebrauchsanleitung Seite 10

5 SETTING LIMITS (continued)
5.1 CREATING LIMITS FOR INDIVIDUAL READINGS
1 Press Menu/Limit Memories/Create Limit Memory/Set Upper
Limit (or 'Set Lower Limit').

2 Use the
3 If required, repeat Step 2 for 'Set Lower Limit' (or 'Set Upper
Limit') and 'Set Nominal'.
4 When all values have been set, use the
'Save Limit Memory n' and press 'Select' to save.
 Limits are specific to the measurement mode in use when created.
5.2 CREATING LIMITS FOR A NEW BATCH
1 Press Batch/New Batch/Batch Limits/Create Limit Memory/
Set Upper Limit (or 'Set Lower Limit').

2 Use the
3 If required, repeat Step 2 for 'Set Lower Limit' (or 'Set Upper
Limit') and 'Set Nominal'.
4 When all values have been set, use the
highlight 'Save Limit Memory n' and press 'Select' to save.
 Limits are specific to the measurement mode in use when created.
 Batch limits can be viewed at any time via Batch/Review Batch/Batch
Information.
5.3 SELECTING SAVED LIMITS
1 Press Menu/Limit Memories/Select Limit Memory or when in
Batching, press Batch/New Batch/Batch Limits/Select Limit
Memory.

2 Use the
press 'Select'.
Only the limits specific to the measurement mode in use are available for

selection.
 Batch limits can be viewed at any time via Batch/Review Batch/Batch
Information.
When a limit memory is in use,
measurement screen, where n = the limit index number.
en-9
R
softkeys to set the required value and press 'Set'.

softkeys to set the required value and press 'Set'.

softkeys to highlight the limit memory required and





is displayed to the right of the
softkeys to highlight
softkeys to
www.elcometer.com