Cleaning And Care - Vitek VT-1992 W Betriebsanleitung

ENGLISH

CLEANING AND CARE

–
Unplug the unit and let it cool down.
–
Wipe the body and lid (3) with a wet cloth.
– Wash baking form (6), paddle (7), measuring cup (8), spoon (9) and hook (10) in warm water with a neutral
detergent.
Note: If the paddle (7) can not be removed from the axle, fill the form (6) with warm water and wait for about 30
minutes.
You may also wash the form (6) and the paddle (7) in a dishwasher.
–
Dry forms (6) and paddle (7) carefully before fixing them in the bread maker.
–
Do not immerse the unit, power cord and cord plug into water and other liquids.
STORAGE
– Before storage clean the bread maker and wait till it is completely dry.
–
Keep the unit away from children in a dry cool place.
TROUBLESHOOTING
PROBLEM
Symbols «EE00» appear on
the display, accompanied by
repeated sound signals.
Symbols «EE01» appear on
the display, accompanied by
5 sound signals
Symbols «ЕЕE» on the display,
accompanied by repeated
sound signals
Symbols «HHH» on the
display, accompanied by
repeated sound signals
Smoke from the ventilation
openings
The baked bread dropped,
the bottom part of the bread
is damp
The bread has stuck to the
walls of the baking form
The bread structure is not
homogeneous or the bread
went wrong
VT-1992.indd 12
CAUSE
Low temperature in the
process chamber
The unit has not cooled
down after the previous
baking cycle
Temperature sensor
breaking
Temperature sensor is not
working because of short
circuit
Ingredients got onto the
heating element
The bread has stayed in
the bread maker for too
long after baking
The bottom part of the
bread has stuck to the
kneading paddle
Wrong mode is selected
Accidental pressing of
«START/STOP» button
during the operation
process
Frequent opening of the
lid during the operation
process
A long power cutoff during
the operation process
The paddles movement is
blocked
12
Solution
Switch the unit off, unplug it, take the form out,
open the lid and wait for 10-20 minutes.
Unplug the unit, take the form out, let the unit cool
down at room temperature
Switch the unit off and contact the authorized
service center
Switch the unit off and contact the authorized
service center.
Switch the unit off by unplugging the power cord
plug from the socket. Take the form out, let the unit
cool down. Wipe the walls of the process chamber
and the heating element with a wet cloth.
When making bread according to this recipe switch
the unit off immediately after the bread is ready
Grease the paddles with oil before assembly
View the available baking programs, select
another program by pressing the «MENU» button
repeatedly
Load all necessary ingredients again and start the
baking process from the very beginning
Open the lid only upon the request of the program
in order to add supplementary ingredients.
Load all necessary ingredients again and start the
baking process from the very beginning
Take the form out and check if the drive is rotating.
In case of any defect contact the authorized
service center
12.09.2012 16:19:25