General Safety Instructions; Scope Of Delivery - Ottobock Pheon 3R62 KD Gebrauchsanweisung

Unallowable environmental conditions
Hygroscopic particles (e.g. Talcum powder), Dust, Sand, Fresh water, Salt water, Acids, Sweat, Urine
Cleaning agents containing solvents
3.5 Reuse and service life
CAUTION
Reuse on another patient
Fall due to loss of functionality as well as damage to the product
Only use the product for a single patient.
►
CAUTION
Exceeding the service life
Fall due to change in or loss of functionality and damage to the product
► Ensure that the approved service life defined in this section is not exceeded.
This prosthetic component has been tested by the manufacturer for 3 million load cycles accord­
ing to ISO 10328. Depending on the patient's activity level, this corresponds to a service life of 3
to 5 years.

4 General safety instructions

CAUTION
Reaching into the area of the joint mechanism
Pinching of limbs (e.g. fingers) and the skin due to uncontrolled joint movement
► Do not reach into the joint mechanism during daily use.
► Close attention is required during assembly and adjustment tasks.
CAUTION
Mechanical damage to the product
Risk of injury due to change in or loss of functionality
► Use caution when working with the product.
► If the product is damaged, check it for proper function and readiness for use.
In case of changes in or loss of functionality, do not continue using the product (see "Signs
►
of changes in or loss of functionality during use" in this section).
► Take any necessary measures (e.g. repair, replacement, inspection by the manufacturer's
customer service, etc.).
Signs of changes in or loss of functionality during use
Noticeable changes in functionality may include poor response, incomplete extension, diminished
swing phase control or stance phase stability, abnormal noises, etc.

5 Scope of delivery

For the scope of delivery, see Figure
A reference number shown in bold in the illustration stands for a single component pack, in which
the product components shown below it can be reordered.
A product component without a reference number in the illustration cannot be reordered separ­
ately.
26
1
on page 2.