General Safety Instructions; Scope Of Delivery; Preparing The Product For Use; Required Tools - Ottobock Genium Protector 4X880 Gebrauchsanweisung

4.3 General safety instructions

CAUTION
Non-observance of safety instructions
Personal injury/damage to the product due to using the product in certain situations.
Observe the safety instructions and the stated precautions in this accompanying document.
►
CAUTION
Improper disassembly, assembly and handling of the product
> Injury due to pinching of body parts.
> Possible injury in case of parts with sharp edges.
Use increased caution during disassembly/assembly and handling of the product.
►
Instruct the patient in the proper disassembly, assembly and handling of the product.
►
NOTICE
Mechanical damage to the product
Change in or loss of functionality due to damage.
Use caution when working with the product.
►
If the product is damaged, check it for proper function and readiness for use.
►
Take any necessary measures (e.g. repair, replacement, inspection by the manufacturer's
►
customer service, etc.).
INFORMATION
When the Protective Cover is installed, the battery charger cable has to point to the upper clos­
ure. A correct knee joint charging process is only ensured with this alignment.

5 Scope of delivery

• 1 pc. 4X880=* Genium Protective Cover
• 1 pc. 4P880=U Upper closure
• 1 pc. 4P880=R Lengthwise closure
• 1 pc. 4P880=* Protector foot cuff
• 1 pc. Instructions for use (qualified personnel)
• 1 pc. Instructions for use (user)

6 Preparing the product for use

6.1 Required tools

• 718H5 Deburring knife
• 743B2 Tape measure
• 627B6=15 Crepe adhesive tape
• 636K13 adhesive (Loctite 241)
• Vibrating/band saw
• 710D20 Torque wrench
6.2 Shortening protective cover
6.2.1 Shortening the Protective Cover – Preliminary Shortening
1) Remove the prosthesis from the residual limb.
2) Remove the shoe from the prosthetic foot.
3) Loosen the foot connection cap of the prosthetic foot.
13