Master CT50P Bedienungs- Und Wartungsanleitungen Seite 7

en
pearing on the rated plate of the device.
►►6. RECOMMENDATIONS
► Read carefully the warnings included in the
manual, as they contain essential guidelines
concerning safety of the installation, use and
maintenance of the device.
► The installation should be performed in ac-
cordance with the standards applicable in the
country, in which it will be used, in accordance
with the guidelines of the manufacturer, by the
qualified personnel from an authorised service
point. An error in the installation may cause inju-
ries of persons and damage, for which the ma-
nufacturer is not responsible.
► Check the dispatch and its content. In case
of doubts, do not use the delivered device and
contact the vendor.
► Do not leave the elements of the packaging
at a place that is easily accessible to children,
as they constitute a source of hazard.
► Do not block the air inlet grates.
► In the case of failure or a defect of the device,
switch it off and do not make attempts to repair
it on your own, but ask the authorised technical
service to intervene.
► From the moment in which you decide to
switch off the device, switch off all other parts
that may constitute a hazard.
► This device may be applied only for purposes
for which it was intended. All other methods of
use will be considered inadequate or even ha-
zardous.
► Make sure that this manual is always atta-
ched to the device.
► If the device is mounted at a place where di-
sabled persons are present, it must be mounted
in a way ensuring easy access to it for the users.
► For combustion, use only solid fuels given
in the table. You must not fill the heater with a
quantity of fuel greater than the one which has
been specified.
► Damping the fire in the furnace by flooding it
with water is not allowed.
► The introduction of structural changes in the
heater on your own is not allowed.
► This appliance is not intended for use by per-
sons (including children) with re¬duced physi-
cal, sensory or mental capabilities, or lack of
experience and knowl¬edge, unless they have
been given supervision or instruction concer-
ning use of the appliance by a person responsi-
ble for their safety.
► Children should be supervised to ensure that
they do not play with the appliance.
►►7. BASIC MAINTENANCE ACTIVI-
TIES
In order to ensure proper functioning and ade-
quate maintenance of the device, we recom-
mend that the authorised technical service per-
form periodical maintenance activities at least
once a year, at best at the end of the heating
season. Any interferences in the device may be
performed only when it is cold.
Cleaning the heat exchanger at the end of
the heating season.
Act in the following way:
► Clean the elements of the heat exchanger
with a small brush.
► Suck the soot which could fall off the repla-
ceable elements in the furnace by means of an
aspirator.
► Replace the grate, if it is deformed.
► Clean the external surface of the heat
exchanger.
Cleaning chimney pipes
Remove all possible obstacles and / or soot,
which could have accumulated in them.
Air fan
Clean it using a brush or compressed air.