Herunterladen Inhalt Inhalt Diese Seite drucken

Rosenbauer R600 Betriebsanleitung Seite 18

Einbau-feuerlöschpumpe
Inhaltsverzeichnis

Werbung

Feuerlöschpumpe R600
Fire Pump R600
Computing maximum lift
Lift is measured from the surface of the
static source to the centerline of the
pump. The height of possible lift is not
affected by the angle of the intake hose,
but depends on the vacuum that the
pump (priming pump) can produce and
by the atmospheric pressure.
Theoretically, at sea level a pump can lift
water 10 m (33.8 feet). A perfect vacuum
is impossible with a fire pump and there
will be loss due to friction, so the maxi-
mum lift is nearer to 6 - 7.6 m ( 20 to 25
feet).
The height that water can be lifted
decreases with altitude by about 0.3 m
(1 foot) for each 300 m (1000 feet) of
elevation.
The weather also affects drafting, but
to a smaller degree.
Seite / Page - 18 -
28.03.1996 / PT / Rev 00
Entlüftungssystem
Da Kreiselpumpen keine selbstsaugenden Pumpen sind, wird das
benötigte Vakuum durch die Rosenbauer Entlüftungspumpe er-
zeugt. Die Entlüftungspumpe ist auf dem Getriebe bzw. Laterne
montiert. Sie wird über einen Riementrieb angetrieben. Die
Entlüftungspumpe ist nur für den Entlüftungsvorgang einzuschal-
ten.
Die Gehäuseteile sind aus korrosionsbeständigem Leichtmetall.
Die mit Dicht- und Führungsringen versehenen Kolbentöpfe sind
zu einer Einheit verschraubt und werden über einen kugelgelagerten
Exzenter mittels Gleitstein betrieben. Die bewegten Teile der
Entlüftungspumpe sind ölbadgeschmiert.
Priming system
Since a centrifugal pump is not a self suction pump, a priming
pump system is installed, which removes air from the pump and the
vacuum created serves to fill the pump with water. The piston
priming pump is mounted on the gear box resp. lantern. It is driven
by a belt. The priming pump has to be engaged for priming
procedure only.
The housing parts are made of corrosion resistant light alloy.
The piston is provided with sealing rings and piston rings and is
driven through a ball bearing mounted eccentic shaft by means of
a sliding pad. The moving parts are oil bath lubricated.
Technische Beschreibung
Technical Description
© 1996

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis