System Design - Sartorius Stedim Biotech BIOSTAT RM 20 basic Bedienungsanleitung

1.3 System Design

12 Design and Function
CultiBag RM 20L, view from the top
1 Dip tube for cell removal
2 Luer septum for sampling or inoculation
3 Luer connection
4 C-Flex tubing with a Luer connector (8" + 4"),
5 C-Flex tubing with a MPC connector (3/8" + 5/8"), with dip tube
6 Sterile filter supply air
7 Sterile filter exhaust air
8 Valve
The next figure shows the schematic design of the BIOSTAT
A BIOSTAT ® RM 20 | 50 basic package consists of the following components:
y Rocker 20 | 50
Power Connection: 100-240 VAC | 600 W, fuse: 6.3A slow-acting, frequency:
50–60 Hz
Noise level according to IEC 61672:2003:
– System switched on, idle, aeration off, 39 dB
– System switched on 42 RPM, aeration off: 62dB
– System switched on, idle, aeration on: 54 dB
– System switched on, 42 RPM, aeration on: 63dB
Material: housing ABS, structural elements chromium steel and aluminum
Protection class: IP23
y Bag Holder 20 or
y Bag Holder 50
Material: ABS
Clamping bars: chromium steel
y Aeration module
with air | CO mixture
2
Mixture regulation: 0.8 – 15 % CO
Gas flow rate: 1 + 1000 ml/min oder 2 + 500 ml/min
y Heating Panel 20 | 50
Power supply: 48 VDC, Device: H1 | H2
Output: 140 W | Heating Panel
Overheating protection: bimetal trip 70°C +/- 5°C
RM 20 | 50 basic:
®
DZ020L-R2BH
DS050L-RMBH
DZ050L-R2CO
2
DZ020L-R2HP