Changing The Fuse; Fig. 40 Fuse Holder - Otto Bock B500-S Bedienungsanleitung

Maintenance, Cleaning and Care
nOTE !
If the brake has been released and the joystick
activated, the controls will emit an error signal
on the control panel. If this is not the case,
something has malfunctioned and the problem
must be eliminated immediately by a specialist
dealer.
10.2 changing the fuse
The 80 A fuse is located in a fuse holder at the rear end
of the battery case (see fig. 40).
Open the cap of the safety holder and exchange the fuse.
Make sure that the fuse is pressed into the centre of the
spring contacts and that it is not at an angle. Close the
cap until you feel it snap back into place.
Page 150
fig. 40 fuse holder
1 Cap, open
2 Fuse, inserted
3 Fuse holder
03/2010 B500 | B500-S