Overview; Basic Operating Procedures; Switching To Menu Mode; Entering The Password - Dräger X-am 7000 Technisches Handbuch

2.1.6

Overview

◄ Menu
|
Info page 52
|
Calibration page 55
|
Settings page 59
a) The sensors shown in this overview serve only as examples and may differ
from the actual sensors installed in the instrument.
Dräger X-am 7000
Info page 52
|
Instrument Info page 52
|
Sensor info page 53
|
Hygiene page 54
Calibration page 55
|
Fresh air cal page 55
|
Mixgas Cal page 56
|
Cfg. Mixgas Cal page 57
|
page 57
a)
CA–CH4
|
page 57
*)
IR–CO2
|
page 57
*)
PI–VOC
|
page 57
*)
EC–NO2
|
page 57
*)
EC–H2S
|
page 57
*)
EC–O2
Settings page 59
|
Instrument page 60
|
Sensors page 65
|
Hygiene page 69
3

Basic operating procedures

3.1

Switching to menu mode

Briefly press the » « key to open the » Quick menu «.

M
or
Press and hold the » « key for more than four seconds to open

M
the menu . You will then be prompted for the password.
3.2

Entering the password

In measurement mode:
Press the » « key for longer than 4

M
seconds; you will be prompted to enter
the password.
Use the » « key to to select the line

M
» Enter password « and press the
» « key.
OK
The input screen opens.
Use the » « and »

M
the four digits of the password, pressing
the » « key to confirm each digit.
OK
- After you have confirmed the last digit,
the menu corresponding to the entered
password is opened.
If the entered password is invalid, a
suitable error message is displayed.
Basic operating procedures
Back to measure
Enter password
Password
_ _ _ _
« keys to set
Password
0 _ _ _
Back to menu
wrong password
9 9 9 9
Enter password
49