Sub-Menu » Sensors; Overview; Sensor Status; Sensor Settings - Dräger X-am 7000 Technisches Handbuch

7.3 Sub-menu » Sensors «
The sub-menu » Sensors « contains the functions for making various
settings for the installed sensors.
7.3.1

Overview

Sensors
|

Status

page 65
|
a)
CA–CH4
|
1)
IR–CO2
|
1)
EC–NO2
|
1)
EC–H2S
|
1)
EC–O2
XX–YYY
|
b)
Gas–Cfg page 65
|
Cal.-Interval page 67
|
Expo-param.
|
Cfg-records
|
Basic Init Ch page 69
|
Fullrange-Mode page 69
a) The sensors shown in this overview serve only as examples and may differ
from the actual sensors installed in the instrument.
b) Functions are disabled if the application mode is active (see page 71).
Dräger X-am 7000
Expo-Param
|
Mean Value Period page 67
|
STEL page 68
|
Short Time Period page 68
|
Total exposition page 68
Cfg-Selection
|
2)
Active Selection page 68
|
2)
Select-Status page 69
7.3.2

Sensor status

- This function is used to active or deactive individual sensors.
Select the menu items » Settings \ Instrument \ Status « in this order,

pressing the » « key after each selection.
OK
Select the desired sensor from the list and press the »

activate (» «) or deactivate it.
7.3.3

Sensor settings

Various functions are provided for each sensor listed in the sub-menu
» Sensors «. The following sections describe the possible settings,
using the CA–CH4 sensor as an example.
Select » CA–CH4 « from the list of sensors and press the »

to open the list of functions:
- » Gas–Cfg «
- » Expo-Param. « with the functions » Mean value period «,
» Short time value «, » Short time period « and » Total exposure «
- » Cfg-records « with the functions » Active selection « and
» Select status «
- » Basic Init. Ch «
7.3.4

Gas configuration

- This function can be used to configure the gas to be measured.
Select the menu items » Settings \ Sensors \ CA–CH4 \ Gas cfg. «

in this order, pressing the »
Select the desired configuration from the list and, if more than one

configuration has been enabled for activation, press the »
(» «), see » Select status « page 69.
Select the desired gas from the list and press the »

activate it (» «).
The Menu » Settings «
« key to
OK
OK
« key after each selection.
OK
OK
« key to
OK
« key
« key
65