Abbreviations; Description; Product Overview; Intended Use - Dräger X-am 8000 Gebrauchsanweisung

Term

Description

Special state If a special state is signalled, the user is
not warned of gas concentrations which
may be dangerous.
The following device features are special
states:
First set-up/configuration with the PC,
switch-on sequence, menu, preparation
phase of the wizards, maintenance wiz-
ard bump test and calibration, warm-up 1
of the sensors, device error, measuring
channel error.
D-Light The D-Light feature allows the user to
check and indicate compliance with cer-
tain settings.
Physical sensors The CatEx, IR, and PID sensor types are
designated as physical sensors. There
are also the electrochemical sensors.
2.5

Abbreviations

Abbreviation Explanation
A1 Pre-alarm
A2 Main alarm
API Application programming interface
CSE Confined space entry, clearance measure-
ment (before entering confined spaces)
IR Infrared
PID Photoionization detector
STEL Short time exposure limit, threshold of an
exposition over a short period of time (gen-
erally 15 minutes).
TWA Time weighted average, average shift val-
ues are generally limited to eight hours
exposure per day per workplace for 5 days
a week during a work lifetime. Observe the
national definition of the occupational
exposure limit.
3 Description
3.1

Product overview

The graphics are displayed on the fold-out page.
Graphic A
1 Display
2 Locking screw for an addi-
tional charging module
3 Power supply unit
Graphic B
1 Gas inlets
Instructions for use |
X-am
4 Charge LED green/red
5 Labelling field (X-am 8000
only)
6 Induction charger
3 Horn
®
8000
Graphic B
2 Thread port for pumps
and calibration adapter
Graphic C
1 LED green/yellow/red
Graphic D
1 feature button 1
2 Feature button 2
Graphic E
1 Status information
Graphic F
1 Clip (optional)
Graphic G
1 Alarm A1, continuous red
light
2 Alarm A2, alternating
red/black light
Graphic J
1 Battery pre-alarm
Graphic K
1 Calibration adapter (grey
coloured ring)
2 Gas inlet
Graphic L
1 Pre-tube bracket (X-am
8000 only)
Graphic M
1 Pump adapter (blue
coloured ring)
2 Gas inlet
3 Dust and water filter
3.2

Intended use

®
Dräger X-am 8000 is a portable gas detector for clearance
measurements and for the continuous monitoring of the
concentration of several gases in ambient air in the workplace
and in explosion-hazard areas.
X-am 8000 can measure up to 7 gasses in accordance with
the installed DrägerSensors (EC, IR, CatEx, PID). The gas
detector can be operated in pump mode (if it is equipped with
a pump) or in diffusion mode.
|
Description
4 Pump outlet and inlet
2 LED yellow/red
3 Feature button 3
2 Navigation bar
2 Socket for support belt for
shoulder version
(X-am 8000 only)
3 STEL alarm
4 TWA alarm
2 Battery main alarm
3 Exhaust
4 Locking screw
2 Pre-tube (X-am 8000 only)
4 Exhaust
5 Locking screw
en
33