Shift Duration; Exposure Status; Application Mode; Exposure Status - Dräger X-am 7000 Technisches Handbuch

7.4.8

Shift Duration

- This function can be used to set the shift duration for exposure
evaluation.
Select the menu items » Settings \ Hygiene \ Shift duration « in

this order, pressing the »
Use the » « and »

M
minutes) and confirm the setting with the »
Adjustable range: 60 to 14400 minutes.
7.4.9

Exposure status

- This function can be used to set the exposure evaluation
individually for each sensor.
Select the menu items » Settings \ Hygiene \ Expos. status « and

the corresponding sensor, e.g. » EC–H2S « in this order, pressing
the » « key after each selection.
OK
Select the exposure status from the list and press the »

to activate it (» «).
TWA:
- Only the total exposure is evaluated.
STEL:
- Only the short-time value is evaluated.
TWA+STEL:
- The total exposure and the short-time value are evaluated.
STEL+DUR:
- The short-time value and the short-time value duration are evaluated.
TWA+STEL+DUR:
- The total exposure, the short-time value and the short-time value
duration are evaluated.
Dräger X-am 7000
« key after each selection.
OK
« keys to set the shift duration (time in
« key.
OK
7.4.10

Application mode

The application mode can be configured to the specific needs of the
customer via the Dräger CC Vision software (version 5.3.3 or higher).
The application mode can be used, for example, if the Dräger X-am
7000 is used with specific instrument and sensor settings in different
applications. The application mode calls up the settings for the whole
instrument stored in the X-am 7000 for the respective application.
A total of 5 application modes can be set by default via theDräger CC
Vision software. The application mode must always be configured and
activated via the Dräger CC Vision software.
If the Dräger X-am 7000 is in application mode, settings can no longer
be modified via the instrument menu and the function keys are disabled.
The following parameters can be modified in the individual applications:
- Sensor activated/deactivated
- Sensor hidden (not shown on the X-am 7000 display, but not
deactivated. In the event of an alarm or fault, the sensor reappears
on the display of the X-am 7000). Integer display, the fractional
part of the value is not displayed on the X-am 7000 display.
- Alarm threshold A1
- Alarm threshold A1, can be acknowledged
« key
- Alarm threshold A2
OK
- Alarm threshold A2, can be acknowledged
- Gas unit
- Leakage mode
- Silent alarm
- Life signal
The configuration procedure is described in the Instructions for Use for
the Dräger CC Vision software under "Application Mode".
The Menu » Settings «
71