WIKA CS6S Betriebsanleitung Seite 65

6. Configuration
Characters,
factory setting
PV
P1
SV
0.0
PV
P2
SV
0.0
PV
Fc
SV
cn
WIKA operating instructions models CS6S, CS6H, CS6L
Selected object, functions, range
OUT1 MV default value (MV manipulated variable)
OUT1 MV can be set, when "Preset 1 ON/OFF" or "Preset output 2 ON/
■
OFF" is selected in "Assignment DC current input".
Preset output 1 ON/OFF:
When there is a defect with the sensor input and no signal can be
determined, when event input is ON, the control is executed with the
preset MV
Preset output 2 ON/OFF:
When the event input is ON, the control is executed with the preset MV.
Setting: 0.0 ... 100.0 % (direct current output: -5.0 ... +105.0 %)
■
Availability:
■
CS6S: If event input has been ordered (options EVI, EXC, CT1/CT2)
CS6H, CS6L: If the serial interface (option RS-485) or event input (options
EVI, EXC, CT1/CT2) has been ordered
OUT2 MV default value
OUT2 MV can be set, when "Preset 1 ON/OFF" or "Preset output 2 ON/
■
OFF" is selected in "Assignment DC current input".
Preset output 1 ON/OFF:
When the sensor burns out during "Event input ON", the control is execut-
ed with the preset MV.
Preset output 2 ON/OFF:
When the event input is ON, the control is executed with the preset MV.
Setting: 0.0 ... 100.0 % (direct current output: -5.0 ... +105.0 %)
■
Available in the following cases:
CS6S: When event input EV2 (option EV2), heating/cooling control (option 3-term
■
control) or event input (options EVI, EXC, CT1/CT2) were ordered
CS6H, CS6L: When event input EV2 (option EV2), heating/cooling control (option
■
3-term control), serial interface (option RS-485) or event input (options EVI, EXC,
CT1/CT2) were ordered
When 019 (heating/cooling control relay output) in "Assignment of event output
■
EV2" is selected.
Controller/transmitter function
Select the controller or the convertor function
■
Controller
cnr
Transmitter
cn8
Only available when OUT1 is a direct current output.
EN
65