WIKA CS6S Betriebsanleitung Seite 15

5. Commissioning, operation
WARNING!
Damage to the instrument through improper use
The area of the display can easily be damaged.
▶
Avoid any contact with hard and sharp objects, or any excessive
pressures.
5.1 Mounting
5.1.1 Model CS6S
Fix the controller vertically to a flat, rigid panel in accordance with the specification (IP66).
Mountable panel thickness: 1 ... 5 mm
1. If a dripping-water tight/dust-tight specification (IP66) is required, then attach the
appropriate seal.
If mounted too close together, side by side, the IP66 specification (dripping-water tight/
dust-tight) can be impaired, in which case, all warranty claims will be void.
When no dripping-water tight/dust-tight specification (IP66) is required, the sealing does
not have to be fitted.
2. Insert the controller with the control panel facing forwards.
3. Insert the mounting frame so that it is in contact with the panel and fasten with screws.
The torque should be about 0.15 Nm.
Insert the controller into the panel cut-out
Tighten screws
(only for model CS6S)
WIKA operating instructions models CS6S, CS6H, CS6L
Attach the mounting clamps
EN
15