WIKA CS6S Betriebsanleitung Seite 56

6. Configuration
Characters,
factory setting
PV
F1o
SV
00.00
EN
PV
E8o2
SV
000
56
Selected object, functions, range
TS1 ON time
Setting the time signal output TS1 ON
■
Corresponds to "TS1 ON time" in the basic setting mode
Setting range: 00:00 to 99:59
■
Only available when 015 (time signal output) is selected in "Assignment event output
EV1".
Assignment of event output EV2
Select the assignment of event output EV2 from the table below
■
Change in the assignment of event output EV2
■
000 No result
001 Alarm output, upper limit value alarm
002 Alarm output, lower limit value alarm
003 Alarm output, upper/lower limit value alarm
004 Alarm output, independent upper/lower limit value alarm
005 Alarm output, upper/lower limit range alarm
006 Alarm output, independent upper/lower limit range alarm
007 Alarm output, deviation high alarm
008 Alarm output, minimum value alarm
009 Alarm output, upper limit value alarm with standby
010 Alarm output, lower limit value alarm with standby
011 Alarm output, upper/lower limit value alarm with standby
012 Alarm output, independent upper/lower limit value alarm with standby
013 Heater burnout alarm output
014 Control loop monitoring alarm output
015 Time signal output
During program control switching to OFF or ON, by the setting of OFF and ON
times within the program step
016 Output during AT
During AT, set to ON
017 End of program
Set to ON when the program end has been reached.
Acknowledge with the
018 Output during communications command
Set to OFF or ON through communications command 00E4H with serial
interface
B0 EV1 output
B1 EV2 output
019 Heating/cooling control
Relay contact output
Control output OUT2 (heating/cooling control)
Only available when event output EV2 (EV2 option) has been ordered.
WIKA operating instructions models CS6S, CS6H, CS6L
button.
0: OFF
1: ON
0: OFF
1: ON