WIKA CS6S Betriebsanleitung Seite 62

6. Configuration
Characters,
factory setting
PV
rLL
SV
200
EN

PV


SV

PV
P
SV
oP
PV
8
SV
0
PV
L
SV
P8
PV
P
SV
0
62
Selected object, functions, range
Transmit output lower limit value
Setting the lower limit of the transmit output
(This value corresponds to 4 mA in the direct current output.)
PV, SV transmission
MV transmission
DV transmission
Only available when "Transmit output" (EXC option) has been ordered.
Step time unit
Selection of the step time unit for the program control
■
Hours : Minutes

n
Minutes : Seconds
c
Only available when "Program control" is selected in "ON/OFF main function".
Recovery of the power supply
Select the program status when the program is interrupted due to power
■
dropout and reestablish
Stops, after the power supply has been restored
FoP
Will continue, after the power supply has been restored
con
Holds, after the power supply has been restored
oL
Only available when "Program control" is selected in "ON/OFF main function".
Program start temperature
Setting the temperature for when the program control starts
■
Setting range: Scaling the lower to the higher limits
■
Only available when "Program control" is selected in "ON/OFF main function".
Start type of the program control
Select the start type of the program control
PV start
P8
PVR start
P8r
SV start
8
Only available when "Program control" is selected in "ON/OFF main function".
Number of repetitions
Setting the number of repetitions for program control
■
Setting range: 0 ... 10,000 times
■
Only available when "Program control" is selected in "ON/OFF main function".
WIKA operating instructions models CS6S, CS6H, CS6L
Lower limit of input range to upper limit of transmit
output
-5.0 % to upper limit of transmit output
Scaling span to upper limit of transmit output