WIKA CS6S Betriebsanleitung Seite 50

6. Configuration
Characters,
factory setting
PV
2
SV
0 0
.
EN
and current
2
value CT2
are displayed
alternately in
the PV display.
PV
LP
SV
0
PV
LP
SV
0
OUT1 gradients
Heating control: When the PV is lower than the SV, the output switches from OFF to ON.
When the OUT1 gradients are set, the output power can be altered through the gradients.
This control is suitable for high-temperature controllers (which are manufactured from
molybdenum, tungsten or platinum etc. and are used between 1,500 to 1,800 °C) which
quickly burn through with fast electrical switching.
Normal output
ON
OFF
50
Selected object, functions, range
Heater burnout alarm 2
Setting the heater current value for the heater burnout alarm 2
■
Corresponds to "Heater burnout alarm 2" in the basic setting mode.
Only available for 3-phase operation
■
and CT2 (current value) is displayed alternately in the PV display.
2
When OUT1 is set to ON, the current value CT1 will be set to the latest
value.
When OUT1 is set to OFF, the instrument stores the last value when
OUT1 was still ON.
Setting range: 20.0 A:
■
100.0 A: 0.0 ... 100.0 A
Setting to 0.0 deactivates the alarm.
Only available when the heater burnout alarm (option CT1/CT2) has been ordered.
Control loop monitoring alarm time
Input of the time for the control loop monitoring
■
Setting range: 0 ... 200 minutes
■
Control loop monitoring alarm span
Defines the temperature when the control loop monitoring alarm is
■
triggered
Corresponds to "Control loop monitoring alarm span" in basic setting
mode.
Setting range: 0 ... 150 °C (°F) or 0.0 ... 150.0 °C (°F)
■
DC voltage, current inputs: 0 ... 1,500
Setting to 0 deactivates the alarm.
Output by gradients
100 %/sec 20 %/sec
1 sec 5 sec
WIKA operating instructions models CS6S, CS6H, CS6L
0.0 ... 20.0 A
10 %/sec
10 sec