WIKA CS6S Betriebsanleitung Seite 39

6. Configuration
Characters,
factory setting
PV
2
SV
0
PV
 2
SV
00.00

PV
 2
SV
0
PV
3
SV
0
WIKA operating instructions models CS6S, CS6H, CS6L
Selected object, functions, range
Step 2: SV
Setting SV2
■
Corresponds to "SV2" in the basic setting mode
■
When program control is selected in the "ON/OFF main function" (see
chapter 6.5 "Engineering mode"), "Step 2: SV" is then selected.
Setting range: Scaling lower to upper limit value
■
Available in the following cases:
When program control in "ON/OFF main function" (see chapter 6.5 "Engineering
■
mode") is selected.
CS6S: If event input has been ordered (options EVI, EXC, CT1/CT2)
CS6H, CS6L: If the serial interface (option RS-485) or event input (options EVI,
■
EXC, CT1/CT2) has been ordered
When "Set point memory" is selected in the "Assignment event input DI1/DI2".
■
Step 2: Time
Setting the time of step 2
■
Setting range:
■
   
When is set, step 2 is paused and the fixed value control is
   
executed through use of the "Step 2: SV".
Only available when program control in "ON/OFF main function" (see chapter 6.5
"Engineering mode") is selected.
Step 2: Dwell time
Setting the delay time of step 2
■
Setting range: 0 to the converted value of 20 % of the input range
■
DC voltage, current inputs: 0 to converted value of 20 % of the scaling
span
Setting to 0 deactivates the delay function.
Only available when program control in "ON/OFF main function" (see chapter 6.5
"Engineering mode") is selected.
Step 3: SV
Setting SV3
■
Corresponds to "SV3" in the basic setting mode
■
When program control is selected in the "ON/OFF main function" (see
chapter 6.5 "Engineering mode"), "Step 3: SV" is then selected.
Setting range: Scaling lower to upper limit value
■
Available in the following cases:
When program control in "ON/OFF main function" (see chapter 6.5 "Engineering
■
mode") is selected.
CS6S: If event input has been ordered (options EVI, EXC, CT1/CT2)
CS6H, CS6L: If the serial interface (option RS-485) or event input (options EVI,
■
EXC, CT1/CT2) has been ordered
When "Set point memory" is selected in the "Assignment event input DI1/DI2".
■
or 00:00 ... 99:59
EN
39