WIKA CS6S Betriebsanleitung Seite 32

6. Configuration
Characters,
factory setting
PV
E8 1
SV
000
EN
PV
E82
SV
000
32
Selected object, functions, range
Assignment event input DI1
Select the event input DI1 from the table
■
Event input
function
No event
000
Set point data
001
Control ON/OFF
002
Direct/Reverse
003
acting
Preset output 1
004
ON/OFF
Preset output 2
005
ON/OFF
Auto/manual
006
control
Remote control/
007
local
Program control
008
RUN/STOP
Hold/Do not hold
009
program control
Program control,
010
advanced function
Integral-acting
011
behaviour
Availability:
■
CS6S: If event input has been ordered (options EVI, EXC, CT1/CT2)
CS6H, CS6L: If the serial interface (option RS-485) or event input (options
EVI, EXC, CT1/CT2) has been ordered
Assignment event input DI2
Select the event input DI2 from the table
■
Range: Such as with "Assignment event input DI1"
■
Availability:
■
CS6S: If event input has been ordered (options EVI, EXC, CT1/CT2)
CS6H, CS6L: If the serial interface (option RS-485) or event input (options
EVI, EXC, CT1/CT2) has been ordered
WIKA operating instructions models CS6S, CS6H, CS6L
Input ON Input OFF
(closed) (open)
Control OFF Control ON
Direct acting Reverse acting
Preset output Usual control
Preset output Usual control
Manual control Automatic
control
Remote control Local
RUN STOP
Continue Do not continue
program program
Advanced Usual control
function
Maintain Usual
integral-acting integral-acting
behaviour behaviour
Comments
Control output OFF
function
Always successful
If the sensor has
burned out, the
control starts with the
preset MV.
The control starts
with the preset MV.
Only effective when
EXC option (external
regulated input) has
been ordered.
Action, when
switched on
Action, when
switched on
Action, when
switched on
Control is resumed
with the maintained
integral value.