5. Commissioning, operation
5.1.2 Models CS6H, CS6L
Fix the controller vertically to a flat, rigid panel in accordance with the specification (IP66).
Mountable panel thickness: 1 ... 7 mm
1. If a dripping-water tight/dust-tight specification (IP66) is required for the CS6H, then
attach the appropriate sealing and note the mounting information - see chapter 2.3
EN
"Dimensions in mm".
2. Insert the controller into the panel cut-out provided.
3. Attach the mounting clamps above and below the case and fix the controller with screws.
The torque is approx. 0.1 Nm.
Insert the controller into the panel cut-out
16
Attach the mounting clamps
WIKA operating instructions models CS6S, CS6H, CS6L