WIKA CS6S Betriebsanleitung Seite 34

6. Configuration
Characters,
factory setting
PV

SV
0
EN
PV
2
SV
0
PV
3
SV
0
PV
4
SV
0
34
Selected object, functions, range
SV1
Setting SV1
■
Setting range: lower to upper limit values of the scaling
■
Available when control output "OFF function" or "Auto/Manual control" in
"ON/OFF main function" selected (see chapter 6.5 "Engineering mode").
SV2
Setting SV2
■
Setting range: lower to upper limit values of the scaling
■
Available in the following cases:
When control output "OFF function" or "Auto/Manual control" in "ON/OFF main
■
function" selected (see chapter 6.5 "Engineering mode").
CS6S: If event input has been ordered (options EVI, EXC, CT1/CT2)
CS6H, CS6L: If the serial interface (option RS-485) or event input (options EVI,
■
EXC, CT1/CT2) has been ordered
When "Set point memory" is selected in the "Assignment event input DI1/DI2".
■
SV3
Setting SV3
■
Setting range: lower to upper limit values of the scaling
■
Available in the following cases:
When control output "OFF function" or "Auto/Manual control" in "ON/OFF main
■
function" selected (see chapter 6.5 "Engineering mode").
CS6S: If event input has been ordered (options EVI, EXC, CT1/CT2)
CS6H, CS6L: If the serial interface (option RS-485) or event input (options EVI,
■
EXC, CT1/CT2) has been ordered
When "Set point memory" is selected in the "Assignment event input DI1/DI2".
■
SV4
Setting SV4
■
Setting range: lower to upper limit values of the scaling
■
Available in the following cases:
When control output "OFF function" or "Auto/Manual control" in "ON/OFF main
■
function" selected (see chapter 6.5 "Engineering mode").
CS6S: If event input has been ordered (options EVI, EXC, CT1/CT2)
CS6H, CS6L: If the serial interface (option RS-485) or event input (options EVI,
■
EXC, CT1/CT2) has been ordered
When "Set point memory" is selected in the "Assignment event input DI1/DI2".
■
WIKA operating instructions models CS6S, CS6H, CS6L