WIKA CS6S Betriebsanleitung Seite 53

6. Configuration
Characters,
factory setting
PV
E8o1
SV
000

PV
A1  A
SV
no
WIKA operating instructions models CS6S, CS6H, CS6L
Selected object, functions, range
Assignment of event output EV1
Select the assignment of event output EV1 from the table below
■
Corresponds to "Assignment of event input EV1" in the basic setting mode.
Change in the assignment of event output EV1
■
000 No result
001 Alarm output, upper limit value alarm
002 Alarm output, lower limit value alarm
003 Alarm output, upper/lower limit value alarm
004 Alarm output, independent upper/lower limit value alarm
005 Alarm output, upper/lower limit range alarm
006 Alarm output, independent upper/lower limit range alarm
007 Alarm output, deviation high alarm
008 Alarm output, minimum value alarm
009 Alarm output, upper limit value alarm with standby
010 Alarm output, lower limit value alarm with standby
011 Alarm output, upper/lower limit value alarm with standby
012 Alarm output, independent upper/lower limit value alarm with standby
013 Heater burnout alarm output
014 Control loop monitoring alarm output
015 Time signal output
During program control switching to OFF or ON, by the setting of OFF and ON
times within the program step
016 Output during AT
During AT, set to ON
017 End of program
Set to ON when the program has finished.
Acknowledge with the
018 Output during communications command
Set to OFF or ON through communications command 00E4H with serial interface
B0 EV1 output
B1 EV2 output
EV1 limit value 0 activated/deactivated
When EV1 limit value is 0, the alarm can be activated or deactivated.
■
Corresponds to "EV1 limit value 0 activated/deactivated" in the basic
setting mode.
Selection:
■
Deactivated
no
Activated
E
Available, when 001 (alarm output, upper limit value alarm) to 006 (alarm output,
independent of lower/upper limit range alarm), 009 (alarm output, upper limit value
alarm with standby) to 012 (alarm output, independent of lower/upper limit range alarm
with standby) is selected with the "Assignment of event output EV1".
button.
0: OFF
1: ON
0: OFF
1: ON
EN
53