WIKA CS6S Betriebsanleitung Seite 51

6. Configuration
6.5 Engineering mode
or
(press in this order and hold
together for 3 s)
or
(press in this order and hold
together for 3 s)
Clarification of the setting items
Characters,
factory setting
PV
Loc
SV
   
WIKA operating instructions models CS6S, CS6H, CS6L
from the RUN mode:
Select engineering mode
Select the relevant setting item
Saving the set data
Selected object, functions, range
Locking the entered value
Locking the set data in order to avoid input errors
■
The object to be locked depends on the selection.
Allteration via keyboard
unlock All settings can
be changed.
Lock 1 No settings can
Loc1
be changed.
Lock 2 In fixed value control, only the SV
Loc2
and limit value can be changed.
In program control, the step SV, step
time and limit value can be changed.
Barrier 3 All settings can be changed.
Loc3
Barrier 4 No settings can be changed.
Loc4
Barrier 5 In fixed value control, only the SV
Loc5
and limit value can be changed.
In program control, the step SV, step
time and limit value can be changed.
Alteration via software
command
All settings can be changed.
All settings other than input
type, controller/converter can be
temporarily changed via software
command.
However, when the instrument
is turned on again, the values
entered are reset to the value
before lock 3, 4, or 5 were
selected.
EN
51