WIKA CS6S Betriebsanleitung Seite 60

6. Configuration
Characters,
factory setting

PV
cnno
SV
EN

PV
cn
SV
6

PV
cnFF
SV
7E8

PV
cn
SV
1

PV
cn
SV
10
PV
8b
SV
O
60
Selected object, functions, range
Instrument address
Setting the instrument number
■
The instrument numbers should be set one after the other when several
instruments are connected with the serial interface, otherwise the
communication is not possible.
Setting range: 0 ... 95
■
Only available when "serial interface" (option RS-485) is ordered.
Transmission rate
Select the same communication speed as the host computer
■
9,600 bps
96
19,200 bps
192
38,400 bps
384
Only available when "serial interface" (option RS-485) is ordered.
Data bit/Parity
Select the data bit and parity
■
8 bits/no parity
8non
7 bits/no parity
7non
8 bits/even
8E8
7 bits/even
7E8
8 bits/uneven
8o
7 bits/uneven
7o
Only available when "serial interface" (option RS-485) is ordered.
Stop bit
Select the stop bits
■
1 bit
1
2 bits
2
Only available when "serial interface" (option RS-485) is ordered.
Response timeout
The controller may react slowly after receiving a command from the host
■
computer.
Setting range: 0 ... 1,000 ms
■
Only available when "serial interface" (option RS-485) is ordered.
SVTC BIAS setting
Input of the BIAS value for the external set point parameter.
■
If the controller is being operated in the SVTC mode (set point parameter via
interface from a master device), the set point provided can have a BIAS value
(offset) overlaid on it.
Only available when "serial interface" (option RS-485) is available.
■
Setting range: ±20 % of the set measuring range or ±20 % of the scaled span (with
■
current/voltage signal input)
The negative minimum value is, however, -1999, -199.9, -19.99 or
-1.999.
WIKA operating instructions models CS6S, CS6H, CS6L