G) Visitor Code - Renkforce 1582598 Bedienungsanleitung

g) Visitor code

Visitor codes are special access codes that can be used once or for a specified period. You can
save up to 10 visitor codes.
• Single-use code: Output #1 will be activated when a valid visitor code is entered. The code
can only be used once.
• Code with a time limit: The visitor code can be used an unlimited number of times during
the specified time period (01 - 99 hours). After this period, the code automatically becomes
invalid.
For security reasons, all visitor codes are automatically deleted in the event of a power
cut.
Saving visitor codes:
• The code lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Enter one of the 10 available code numbers (
• Choose the type of visitor code:
.....
• Enter the desired visitor code. The visitor code can have 4 to 8 digits.
Important!
In "Auto entry" mode (see section 12. m), all codes must be the same length (e.g. if
the master code is 5 digits, the user codes must also be 5 digits).
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash twice to indicate that the visitor code has been saved.
92
.
Single-use code
Time limit of the visitor code in hours (01.....99 hours)
..... ).