B) Using The Code Lock - Renkforce 1582598 Bedienungsanleitung

b) Using the code lock

The code lock is ready for use once the configuration steps in section 14. a) have been com-
pleted. The "MAINS" LED will flash slowly to indicate that the lock is in normal mode (waiting
for a code).
User #1, #2 or #3 now wants to access the building using his/her access code
• The code 1111 was assigned to user #1. User #1 must enter the following code to activate
output #1:
• The code lock will beep to indicate that the correct code has been entered (the "MAINS" LED
will turn on and then flash to indicate normal mode).
Output #1 will be activated for 3 seconds (the "DOOR" LED will turn red).
• User #2 must enter their personal code to activate output #1:
• User #3 must enter their personal code to activate output #1:
User #4 wants to open the garage door
• The code 5555 was assigned to user #4. User #2 must enter the following code to activate
output #1:
• The code lock will beep to indicate that the correct code has been entered (the "MAINS" LED
will turn on and then flash to indicate normal mode).
Output #2 will be activated for 15 seconds (the "ALARM" LED will turn red).
116