F) Code For Silent Alarm (Duress Alarm) - Renkforce 1582598 Bedienungsanleitung

f) Code for silent alarm (duress alarm)

If you are forced to enter an access code under duress, you can trigger a silent alarm (duress
alarm) by entering a special code.
When an alarm system is connected to the code lock, this code activates output #1 and the
"DU OUT" output, which triggers a silent alarm (e.g. voice message sent via telephone).
This feature is not affected by other settings and is permanently enabled.
You can save up to 10 different duress codes.
Saving a duress code:
• The code lock must be in programming mode (see section 12 a for details).
• Enter programming code
• Enter one of the 10 available memory slot numbers (
• Enter a 4 - 8 digit personal duress code (e.g.
Important!
When the "Auto entry" feature is enabled (see section 12. m), all codes must be the
same length (e.g. if the master code is 5 digits, the superuser/user/visitor/duress
codes must also be 5 digits).
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash two times to indicate that the duress code has been saved.
Example:
(a) (b)
(a) Programming code for silent alarm (duress alarm)
(b) Memory slot number = 1 (choose from 0 - 9)
(c) Duress code = 7878
(d) Saves the code (the lock will beep twice and the "MAINS" LED will flash two times).
90
.
(c) (d)
..... ).
).