P) Configuring An Open Door Warning Tone - Renkforce 1582598 Bedienungsanleitung

p) Configuring an open door warning tone

You can set the code lock to beep when the door is not closed within a certain time period.
Before using this feature, ensure that you have connected a door sensor (with NC
contact) to the corresponding input on the code lock (see instructions on terminal 13
in section 6).
Follow the steps below:
• The code lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Select the desired function:
.....
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash two times to indicate that the setting has been saved.
The warning tone will stop when the door sensor registers that the door has been
closed.
Example: The warning tone is played when the door has been open for 30 seconds
(a) (b) (c)
(a) Start programming
(b) 30 second delay
(c) Saves the code (the lock will beep twice and the "MAINS" LED will flash two times).
For example, if someone opens the door with a valid user code and holds the door
open with an object, the code lock will give off a warning tone after 30 seconds. The
warning tone will stop when the door is closed.
.
Warning tone off
Activation of the warning tone after 1.....999 seconds
107