F) Code For Silent Alarm (Duress Alarm); G) Visitor Code - Renkforce 1582598 Bedienungsanleitung

f) Code for silent alarm (duress alarm)

The following section only applies to single-user mode. For instructions on multi-user
mode (default mode), refer to section 12.
• The code lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Enter the desired duress code, e.g.
In single-user mode, the duress code must be four digits long. As mentioned in section
13, you can only configure one duress code.
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash two times to indicate that the duress code has been saved (the old code will
be overwritten).

g) Visitor code

The following section only applies to single-user mode. For instructions on multi-user
mode (default mode), refer to section 12.
• The code lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Choose the type of visitor code:
.....
• Enter the desired visitor code, e.g.
In single-user mode, the visitor code must be four digits long. You can only configure
one visitor code in single user mode.
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash two times to indicate that the visitor code has been saved (the old code will
be overwritten).
112
.
.
Single-use code
Time limit of the visitor code in hours (01.....99 hours)
.
.