H) Visitor Code - Renkforce IP65 Bedienungsanleitung

h) Visitor Code

Visitor codes are special access codes that can be assigned either as one-time codes or as
codes with a time limit.
• One-time code: If a valid visitor code is entered, output #1 will switch; the visitor code is then
rendered invalid and stops working.
• Code with time limit: The visitor code can be used any number of times during an adjustable
period (1 - 99 hours). Afterwards, the visitor code will automatically become invalid and stop
working.
At a power outage, all visitor codes are automatically deleted for reasons of safety,
since the internal clock of the code lock is also reset.
Proceed as follows to programme the visitor code:
• The code lock must be in programming mode; see chapter 11. b).
• Enter the programming code
• Enter a visitor-ID (in the range from
You can equip up to 50 different visitors with a separate code, which is sufficient for
most uses.
When a new visitor code is programmed for the same visitor-ID, the new code will
overwrite the old code.
• Programme the type of visitor code:
......
• Enter the desired visitor code. The visitor code may have 4- 8 digits.
Important!
If you switch on the "Auto-Entry" function (see chapter 11. m), all codes must have the
same length (e.g. master code + user code + visitor code 5 digits).
• Confirm your input with the
• The code lock emits two beeps; programming is saved.
94
.
One-time code
Duration of validity of the visitor code in hours (1 - 99 hours)
Deleting all visitor codes
button.
to ).