B) Selecting Single User Mode; C) Selecting Multi-User Mode - Renkforce 1582598 Bedienungsanleitung

b) Selecting single user mode

The master code must be four digits long. If you have set a 5 - 8 digit master code,
change the master code before switching to single user mode.
• The code lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash two times to indicate that the setting has been saved.
• Press the button to exit programming mode.

c) Selecting multi-user mode

This is the standard mode described in section 12.
Switching from single-user to multi-user mode is equivalent to restoring factory set-
tings (see section 12. b).
In multi-user mode, you can program up to 100 different user codes for output #1. The codes
can be 4 - 8 digits long (e.g. 1234, 123456, 98765432). You can program up to 10 different user
codes each for outputs #2 and #3.
You can delete and add user codes at any time, making this mode ideal for use in an office
where many people require access.
• The code lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Press the button to confirm your entry. The "MAINS" LED will flash quickly for a few
seconds and the memory will be cleared. The code lock will beep twice and the "MAINS" LED
will flash two times to indicate that the setting has been saved.
• Press the button to exit programming mode.
110
.
.