M) Selecting The Access Mode - Renkforce 1582598 Bedienungsanleitung

m) Selecting the access mode

There are two ways for the code lock to recognise a code:
• Manual access mode
After you enter a user code, you have to press the
The codes (master code, user code, superuser code, visitor code and duress code) can be
4 - 8 digits long.
Choosing codes with different lengths reduces the likelihood of unauthorised people gaining
access by attempting to guess the code.
• "Auto entry" mode = Automatic access mode
In this mode, you do not need to press the
The code lock checks the code automatically after entry (e.g. 5 digits). If the user code is
correct, the code lock will activate the corresponding output.
This mode can be used to make access quicker when you need to grant access to many
people.
Important!
All codes (master code, user code, superuser code, user code, duress code) must
have the same number of digits (e.g. 5 digits).
The codes will not work if they have different numbers of digits.
Delete all previous settings before switching from manual to automatic access mode
(see section 12. b) for details). After switching to automatic mode, change the master
code to the desired length (e.g. 5 digits). You can then complete the other settings.
Proceed as follows to select the access mode:
• The code lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Select the desired function:
Manual access mode (default setting)
Automatic access mode
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash two times to indicate that the setting has been saved.
104
button after entering a code.
.
button to confirm your entry.