D) Superuser Code - Renkforce 1582598 Bedienungsanleitung

d) Superuser code

The superuser code allows you to manually enable the outputs. It is not affected by time restric-
tions or system locks.
It can also be used to permanently enable output #1 (and the connected door opener).
Saving the superuser code:
• The code lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Enter a 4 to 8 digit code (e.g.
Important!
In "Auto entry" mode (see section 12. m), all codes must be the same length (e.g. if
the master code is 5 digits, the user codes must also be 5 digits).
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash twice to indicate that the superuser code has been saved.
The existing superuser code will be overwritten.
Deleting the superuser code:
• The code lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash twice to indicate that the superuser code has been deleted.
Function 1: Enabling/disabling output #1, #2 or #3
Enter the superuser code like a standard user code. The corresponding output will be enabled/
disabled (the superuser code will reset the enabled output if you have set a very long timer (see
section 12. h) for details)).
Example: The Superuser-Code was set to "6789":
84
.
.
Enable/disable output #1
Enable/disable output #2
Enable/disable output #3
).