Restoring Factory Settings; Setting The Master Code - Renkforce 1582598 Bedienungsanleitung

b) Restoring factory settings
All existing settings and programs can be deleted using a special code.
The master code will not be reset.
Follow the steps below:
• The code lock must be in programming mode (see section 12. a) for details).
• Enter the code
• Press the button to confirm your entry.
• The code lock will beep and the "MAINS" LED will flash quickly to indicate that the settings
are being deleted.
This process may take several seconds if there is a large amount of data.
• When the data has been deleted, the code lock will beep twice and the "MAINS" LED will stay
constant to indicate that programming mode is enabled.
• All settings and programs have now been reset to the factory settings (except the master
code).
c) Setting the master code
Important!
In "Auto entry" mode (see section 12. m), all codes must be the same length (e.g. if
the master code is 5 digits, the user codes must also be 5 digits).
The master code is used to enable programming mode (see section 12. a) for details). It cannot
be used to activate any of the outputs.
Follow the steps below:
• The code lock must be in programming mode (see section 12. a) for details).
• Enter the programming code
• Enter the new master code (e.g.
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash two times to indicate that the master code has been saved (the old code will
be overwritten).
Write down the new master code and store it in a safe place. If you forget the master
code, follow the instructions in section 11 to enable programming mode and set a new
code.
.
.
).
83