d) Programming the master code/user code
The following section only applies to single-user mode. For instructions on multi-user
mode (default mode), refer to section 12.
• The code lock must be in programming mode (see section 12. a) for details).
• Enter the programming code:
Program the master code
Program the user code for output #1
Program the user code for output #2
Program the user code for output #3
• Enter the desired four-digit code.
In single-user mode, all codes must be four digits long. In single user mode, you can
only configure one user code for each output (as described in section 13).
• Press the
button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash two times to indicate that the code has been saved (the old code will be over-
written).
e) Programming the superuser code
To program the superuser code, follow the instructions in section 12. c). In single user mode, the
superuser code must be four digits long.
Saving the superuser code:
• The code lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Enter the superuser code (e.g.
In single user mode, the superuser code must be four digits long.
• Press the
button to confirm your entry.
• The code lock will beep twice and the "MAINS" LED will flash two times to indicate that the
superuser code has been saved (the old code will be overwritten).
.
).
111