Renkforce 1582598 Bedienungsanleitung Seite 106

Follow the steps below:
• The code lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Select the desired function for output #1 (e.g. a connected door opener).
B riefly press the door opener button to release the door opener. To set the activation
time for the door opener (output #1), refer to the instructions in section 12. h).
The door opener will be activated approximately 5 seconds after you press the door
opener button. The code lock will beep during this period.
The door opener will be activated approximately 10 seconds after you press the door
opener button. The code lock will beep during this period.
Hold down the door opener button for 5 seconds to activate the door opener. The code
lock will beep during this period.
Hold down the door opener button for 10 seconds to activate the door opener. The code
lock will beep during this period.
These modes can only be used with the door opener button, not to activate the output
with a user code.
If the door opener button is released too early when selecting modes
internal timer will be reset and output #1 will not be activated.
For safety reasons, instructions should be placed next to the door opener button. For
example, if the delay is set to 5 seconds, the instructions should inform the user to
hold down the door opener button for at least 5 seconds.
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash two times to indicate that the setting has been saved.
106
.
or , the