Beeps And Led Indicators - Renkforce 1582598 Bedienungsanleitung

10. Beeps and LED indicators

The four LEDs on the front of the code lock (see diagram in section 7, positions A, B, C and D)
have the following functions:
Amber "MAINS" LED (A)
Confirms button presses and indicates functions together with the built-in buzzer. The following
signals are given:
Status
Normal mode
Program mode is enabled
Button press
Correct code
Wrong code
DAP jumper was not reset to the
default position ("OFF")
Output is activated
* The beep tones for entering a code can be disabled (program code 83).
** The long beep tone (indicating an active output) can also be disabled (program
code 81).
Green/red "DOOR" LED (B)
The LED turns green when output #1 (for the door opener) is activated.
If output #1 is locked (e.g. by entering the superuser code or program code 71), the LED turns
red.
Red "ALARM" LED (C)
Turns on when output #2 is activated.
Green "AUX" LED (D)
Turns on when output #3 is activated.
80
Beeps *
-
-
1x short beep
2x short beeps
5x short beeps
Constant beep
1x long beep **
LED indicator
Flashes once every two
seconds
LED stays constant
1x short flash
2x short flashes
5x short flashes
Constant flash
-