Renkforce 1582598 Bedienungsanleitung Seite 96

Set output #1, #2 or #3 to toggle mode:
When a valid user code is entered, the corresponding output stays activated until a user code is
entered again. Use this mode to control (arm/disarm) an alarm system.
Follow the steps below:
• The code lock must be in programming mode (see section 12. a) for details).
• Enter the programming code for corresponding output:
Set output #1 to toggle mode
Set output #2 to toggle mode
Set output #3 to toggle mode
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash two times to indicate that the setting has been saved.
Example 1: Set output #1 to toggle mode
(a) (b)
(a) Set output #1 to toggle mode
(b) Saves the setting (the lock will beep twice and the "MAINS" LED will flash two times)
Example 2: Set output #2 to toggle mode
(a) (b)
(a) Set output #2 to toggle mode
(b) Saves the setting (the lock will beep twice and the "MAINS" LED will flash two times)
Example 3: Set output #3 to toggle mode
(a) (b)
(a) Set output #3 to toggle mode
(b) Saves the setting (the lock will beep twice and the "MAINS" LED will flash two times)
96